page1
Exactly how to upgrade Toyota 4Runner interior Lights to LEDs within 20 minutes

Today I will reveal you exactly how to replace the interior lighting on a 2014 Toyota 4Runner with very power LED replacements light bulbs detailed. These setups are extremely straightforward, it needs to only take about 15 minutes with simply basic devices called for. let's start.


We'll begin with the map lights which you'll need a plastic wedge removal tool for to take the lens off.

Just pry it right into the back of the lens, simply pop that off, and also you'll take out your factory T10 bulb, after that you'll take the very power T10 canbus LED bulb, insert it directly into the housing, ensuring you have a great protected fit and then you'll reinstall the OEM lens cover back right into area.


Prior to full, you'll wish to evaluate it to see to it you have the bulb put properly. Conform the opposite side, follow the same steps to complete the map light installation.


Carry on to the vanity light place, which begins when you open the mirrors. We'll take our plastic wedge removal tool and also function it way back via the lens to tear this off to gain accessibility to the original bulb. You can draw out, take your information as well as Super canbus led 194 LED light bulb, insert it directly right into the outlet.

And then we'll reinstall the outlet back into location and also test the light bulb to see to it that it's functioning correctly.

For the dome light place, we'll take our plastic removal tool as well as work our method via the factory lens in between the housing and lens to pop off the clips, which are holding it in place and afterwards when the lens is gotten rid of. We'll remove the OEM bulb with our tool. While original bulb is taken out, we'll take LED bulb as well as put directly right into the outlet. Once it's been set up, you'll intend to evaluate it to make sure that it's functioning appropriately, and after that we'll reinstall the lens cover to complete the installment.

For the cargo light places, you utilize your plastic wedge device and also insert it right into the side of the housing to depress a clip to ensure that it appears of the out of the outlet. We'll simply depress the clip to pull the housing off the automobile, make it a little bit easier to function with. They'll see 4 clips holding on the lens, which we can use the plastic tool to kind of job our method around. So we can pop it off simpler. When you've popped off the lens, you can take the OEM bulb out quickly, take your canbus led bulb as well as insert it straight right into the housing. See to it you have actually the LED shining the right means. And also make certain it's securely attached, examination it by connecting it back in so that you have the correct polarity. After that you'll re-install your lens cover, seeing to it you snap whatever firmly in position, placing the housing back in and afterwards move over the other side, complying with the exact same steps to finish the installment of the trunk lights.

For the four-door light places, we'll take our plastic wedge device and also insert it on the side of the housing to dispirit a clip to ensure that we obtain the setting up off the automobile. We'll pull the housing down, dispirit this clip to take the assembly off the automobile totally. We'll press back on the housing so that we can remove this lens setting up, take the OEM light bulb out, take our LED replacement bulb, insert it straight into the housing, re-install the lens cover back on, see to it you break everything back in place, after that you'll reinstall the assembly back onto the OEM connector, install it back onto the automobile, test it to ensure it's functioning appropriately and afterwards we'll place it back on the lorry, snap it into location. Adhere to the very same procedure for all 4 doors to complete the LED installment.

While all point total, you'll have a lot more useful output in the cabin at night along with a great light look. Installment just took about 20 mins for the whole car with just a plastic wedge tool required, really basic, right?